MICRO-EPSILON TIM 160 Especificaciones descargar pdf (Pagina 42)

Configuration

thermoIMAGER TIM 42

Using New / Delete buttons you can create a new measure area (measure points/rectangle) or delete

existing measure area. Press Up/Down to position individual measure areas within the list.

One measure area from the list can be appointed as the Main area (temperature of the main area

converted) into electrical signal can be also transmitted via Process Interface (PIF).

By selecting Show in image measure areas can be displayed in the infrared image.

Ticking off the Show grippers/gripper labels enables you to change the position or the size of defined

measure areas by using the mouse.

Use the Name field to rename each measure area. Mode allows you to define the type of area (measure

points or rectangle).

Specify what temperature value - minimum, mean value or maximum - should be shown. Using Bind to

profile you can assign each measure area to specified temperature profile.

In the Position section the exact position of the measure area within the camera image can be defined. If

desired the area can represent a hot spot (spot with highest temperature in the image) or a cold spot (spot

with lowest temperature in the image).

Fig. 10.3: Measure area assigned to a

temperature profile (measure point)

Fig. 10.4: Measure area assigned to a

temperature profile (rectangle)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 79 80

Sin comentarios

MICRO-EPSILON TIM 160 Especificaciones Pagina 42